Walkthrough model workflow reuse: Difference between revisions
No edit summary |
No edit summary |
||
| Line 33: | Line 33: | ||
Now can save the workflow itself, probably providing first a different name than the default. | Now can save the workflow itself, probably providing first a different name than the default. | ||
[[File:ReuseWorkflowChangeName.png|thumb|center|300px|Provide a name for the workflow. It will be saved later into the catalogue]] | [[File:ReuseWorkflowChangeName.png|thumb|center|300px|Provide a name for the workflow. It will be saved later into the catalogue]]. | ||
Once the workflow defined on the first model is defined we can move to a different filament and pick its extremal points with controls [1] and [2]: | |||
[[File:modelReuseFilament2.png|thumb|center|300px|Next filament is chosen]] | |||
and then define a new filament model, and click on their points. But in this case, afterwards we save the model without further edition | |||
{|style="margin: 0 auto;" | |||
| [[File:modelReuseFilament2Points.png|thumb|upright|400px| ]] | |||
| [[File:modelReuseFilament2Save.png|thumb|upright|300px| ]] | |||
|} | |||
and move to the generation of a further filament model | |||
{|style="margin: 0 auto;" | |||
| [[File:modelReuseFilament3.png|thumb|upright|400px| ]] | |||
| [[File:modelReuseFilament3points.png|thumb|upright|300px|three filament models ]] | |||
|} | |||
Revision as of 04:35, 17 August 2016
This walkthrough shows how to reuse the geometric computations performed on a single model onto a larger set of models.
We can use a synthetic tomogram containing different tubular structures. In this catalogue, we open the tomogram with dtmslice, and then define a filament model following the usual procedure, so that we end up with a single model containing a set on points.
We will now define a workflow, i.e., a method of converting points into crop_points.
We open the workflow editor of the active model, and start operating the steps, checking graphically the result of each parameter selection. We create first a backbone, selecting the interval between backbone elements.

And check how the results looks like:
We then proceed for the next step: selection of the interval (in pixels) between two consecutive crop points.

And check again the results:
... not forgetting to save the model into the catalogue. The model will contain the generated crop_points and also the parameter values used to generate them.

Now can save the workflow itself, probably providing first a different name than the default.

.
Once the workflow defined on the first model is defined we can move to a different filament and pick its extremal points with controls [1] and [2]:

and then define a new filament model, and click on their points. But in this case, afterwards we save the model without further edition
and move to the generation of a further filament model






