The GPUs accessible by your system in an interactive session (i.e., assuming you can directly ssh onto the node where the GPUs are installed) can be shown with nvidia-smi.
Remember that some GPUs are dual devices. A single NIVIDIA K80 will show as two different devices, with two different integer numbers.
Setting the identifiers
You need to make certain that the identifiers that you pass to the project are correct. During unfolding, Dynamowill not check that the device numbers are correct!
On the GUI
===Through the command line==-
The parameter is called gpu_identifier_set (short gpus). You can set it into a project using dvput, for instance:
dvput myProject gpus [0,1,2,3]
In some rare systems, you might to be required to manually set the environment variable CUDA_VISIBLE_DEVICES to the device numbers that you already selected inside Dynamo.